• SEARS OWNER'S MANUAL MODEL NO. 225.581508 15' TRANSOM 225.581498 20' TRANSOM GAMEFISHER CAUTION: Read and Follow 15 HORSEPOWER all Safety Rules OUTBOARD MOTOR and Instructions WITH 6 GALLON REMOTE TANK Before Operating This Equipment • Installation • Operation • Customer Responsibilities •. • SAFETY RULES BOATER'S RESPONSIBILITIES The operator (driver) is responsible for the correct USING AN OUTBOARD THAT EXCEEDS THE MAXI- safe operation of the boat and safety of its occupants HORSEPOWER LIMIT OF A BOAT CAN: and general public. It is strongly recommended that 1. • CONGRATULATIONS.

BOAT PARTS!: Eska, Tecumseh, Sears parts - New OMC parts OMC Service manuals New Mercury parts Used OMC parts Used Mercury parts OMC manuals Muncie Gear Co. Shop for ESKA 5.0 H.P. OUTBOARD MOTOR repair parts for model 14106b at Sears PartsDirect. Find parts, manuals & diagrams for any ESKA 5.0 H.P. OUTBOARD MOTOR repair project.

PRODUCT SPECIFICATIONS You are to be congratulated on your selection of this Engine 15 HP Outboard Motor which will give you years of satisfactory Horsepower Rating @ 6000 RPM service. Your Gamefisher is the end product of years of Recommended research, engineering and development. • TABLE OF CONTENTS CUSTOMER RESPONSIBILITIES. 17-24 SAFETY RULES. MOTOR SPECIFICATIONS.

SERVICE AND ADJUSTMENTS.WARRANTY.STORAGE.26-27 MOTOR ACCESSORIES.TROUBLESHOOTING POINTS.INSTALLATION. REPAIR PARTS. MOTOR NOMENCLATURE. PARTS ORDERING.REAR COVER OPERATION. • OUTBOARD MOTOR ACCESSORIES These accessories were available when the outboard motor was purchased. They are also available at most Sears retail outlets, catalog and service centers. Most Sears stores can order repair parts for you, when you provide the model number of your outboard motor.

3d Wallpapers For Mobile For Touch Screen Free Download here. • GENERAL INFORMATION LANYARD STOP SWITCH DISADVANTAGES: INADVERTENT ACTIVATION THE SWITCH IS ALSO A POSSIBILITY. THIS COULD The purpose of the lanyard stop switch is to turn off CAUSE ANY, OR ALL, OF THE FOLLOWING POTEN- the engine ignition whenever the operator (when TIALLY HAZARDOUS.

• INSTALLATION BOATTRANSOM TRANSOM TYPE • Make sure the transom of your boat is designed for mounting an outboard motor. (Figure 1) The keel should be tapered from a point about 30' (76.2cm) ahead of the transom so that it is no more than 1/2' (1.27cm) thick at the transom. • OPERATION KNOW YOUR OUTBOARD MOTOR Read this owner's manual and safety rules before operating your outboard motor. Compare the illustrations (Figures and 5) with your outboard motor to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. • OPERATION TO USE YOUR OUTBOARD MOTOR MOTOR TILT • To tilt the motor up out of the water push tilt release lever down to 'Release' position.

(Figure 6) • Grasp handle on back of motor cover and pull forward until end of travel of tilt stop. • OPERATION SHALLOW WATER DRIVE TILLER HANDLE POSITIONS The shallow water drive bar allows the motor to operate The motor is equipped with a throttle arm that drops at low speeds in shallow water. Down for convenient handling during transportation storage. To drop the handle, lift the arm up slightly. • OPERATION MOTOR TILT ANGLE IMPORTANT: ADJUST MOTOR TILT ANGLE, IF NECESSARY, BY CHANGING THE POSITION OF THE LOCK BAR SO THAT THE PROPELLER SHAFT IS PARALLEL TO THE SURFACE OF THE WATER WHEN THE BOAT IS PLANING. SEE FIGURE 15 TO DETERMINE CORRECT MOTOR ANGLE. • OPERATION BEFORE STARTING ENGINE FOR A PROPER FUEL MIX OIL SELECTION Recommended lubricant and gasoline must be properly mixed or serious damage will result to the engine.